Profile Projectorbulb replacement procedure

Profile Projector replacement procedure:

Profile Projector replacement procedure is as follows:

The power switch 1 off two dimensional projector front panel;

2 out of the two dimension projector power line;

3 open the right door two dimensional projector;

4 loosen the two dimension door opposite screw loosening of the projector, down lamp holder assembly removed.

5 will be the two dimension projector lamp holder assembly from the door out of the projector;

6 sheared by 2 connecting line. And the worst holder out.

7 install a new lamp holder, locking screws two lamp holder.

8 mounted on the lamp filament, guarantee level, adjust the lighting in the mirror position. The filament light bulb filament overlap and mirror imaging.

The 9 locking socket.

10 the connection socket group on the ground, and wrapped with insulation.

11 lamp group from a small door back projector.

12 boot detection.

Be careful.

To install the two dimension projector lamp holder, must adjust the lighting position.

To ensure that looking down from the bulb. The filament light bulb filament overlap and mirror imaging.

Then the whole assembly of Ho projector lamp.

无锡市森乾机械量仪有限公司专业经营万濠投影仪，万濠全自动影像仪,万濠影像测量仪。提供完善的售前售中和售后服务。